Simple Methods To Replace A Mazda 6 Car Radio
There are many models of Mazda 6 and people try to upgrade its stereo from time to time. There are many generations in this and techniques always like to keep themselves updated with the latest technology. But before selecting the newer versions of radios and replacing, the first step is to remove the former radio. This articles deals on how to remove the radio from Mazda 6. The steps that are given in this article can be worked on with models that were released between the years 2003 and 2008.
For completing this task you will require a socket wrench, pliers and a screw driver.
Put the gear in the neutral position, set the parking brake and turn off the engine. After following these steps, open the hood of the car and disconnect the wire from the negative terminal of the battery. It is absolutely necessary that you disconnect the battery from the car before proceeding to remove the radio from the car. If the battery is not disconnected from the car then there may be short circuiting or electrical shocks. So make sure that you follow this step for your own safety.
Get into your car. Make sure your car’s gear system is in neutral position. The engine is turned off and hand brake is applied. Parking brake is the other name of the hand brake. The negative terminal of the car’s battery is disconnected. The gear shifting knob is twisted counter clock wise direction and the knob is removed carefully. The center console is smashed and the cup holder is grabbed and removed carefully.
Once the console is removed completely you can see two screws. These screws are removed using appropriate screw drivers. These two screws can be found at the bottom side of the weather controlling panel.
You will find that the radio and the climate control are mounted on the same assembly. Loosen the entire assembly so that the whole setup can be removed. The air vent covers are included in the panel. Remove this cover. Turn the cover upside down. There will be twelve screws located on the cover. These screws are responsible for mounting the climate and the radio controls. Remove all the 12 screws with the help of a screw driver. Once all the screws are removed, the radio can be removed from the car.
After removing the old radio, you can now install the new radio. The steps involved in the installation of the radio are exactly the reverse of the steps mentioned above. Replace the screws and the covers. Now put the gear back to its original position and connect the negative cable back to the negative terminal of the car’s battery.
This article therefore throws light on all aspects of removing the battery and the radio. It is essential to remove the battery to prevent any case of short circuit in the car while working on this removal. Now you know how to remove the radio from Mazda 6.
Learn more about Autoradioblende. Stop by Author Name’s site where you can find out all about radio mounting kits and what it can do for you. Don’t reprint this exact article. Instead, reprint a free unique content version of this same article.